Hi All,
I would appreciated some advice. There is a warning message causing me problems during a BDC update. When I go into an order operation in change mode I want to:
1. Go into "Requirements Assignment".
2. Uncheck the checkbox: "Only from w/p".
3. Enter a number in the "Person" field.
4. Enter a number in the "Work" field.
5. Do steps 3&4 multiple times, while pressing "Enter" between.
6. Save.
When I go into BDC mode "A" It will run until I enter a person that throws a warning message: "The selected person is not qualified". But the cursor disappears. The popup box which contains the function codes just disappears so I can't carry on with the BDC.
When processing in dialogue mode I would simply press enter and continue my work but in the BDC because the popup box disappear I cannot do this. Any advice on how to get past this issue would be greatly appreciated.
Thanks.
Regards, Martin.